Welcome to KNJ bearing 中文版 ENGLISH
+86-13963009636

You are here:Home > PRODUCTS > Thrust roller bearing

29276 Thrust roller bearing
Name

29276 Thrust roller bearing

New Model 29276 Old Model 9039276
d(mm) 380 D(mm) 520
H(mm) 85 W(kg) 52.8
Cr(kN) 1580 Cor(kN) 7430
Grease speed(r/min) 700 Oil speed(r/min) -
Type Thrust roller bearing
Tel +86-635-2819662

Bearing sample drawing

Introduction of bearing information

Thrust roller bearings are used to support axial and radial combined loads, but the radial load must not exceed 55% of the axial load. Compared with other thrust roller bearings, this type of bearing has a low friction factor, a high rotational speed, and has a self-aligning performance.

Thrust cylindrical roller bearings and thrust tapered roller bearings are suitable for low speed applications. Thrust tapered roller bearings have slightly higher rotational speed than thrust cylindrical roller bearings. Thrust cylindrical roller bearings are separate bearings that can only withstand one-way axial loads and slight impacts, and can limit the axial displacement of the shaft (or casing) in one direction, so it can be used as one-way axial positioning. However, its carrying capacity is much larger than that of thrust ball bearings. When the roller rolls, the roller speed is inevitably slipped on the ferrule raceway due to the different linear speeds at both ends of the roller. Therefore, the limit rotation speed of such a bearing is lower than that of the thrust ball bearing, and is usually only suitable for low-speed operation.

Recommended bearing model