Welcome to KNJ bearing 中文版 ENGLISH
+86-13963009636

You are here:Home > PRODUCTS > Angular contact ball bearing

7200C Angular contact ball bearing
Name

7200C Angular contact ball bearing

New Model 7200C Old Model 36200
d(mm) 10 D(mm) 30
H(mm) 9 W(kg) 0.031
Cr(kN) 5 Cor(kN) 2.35
Grease speed(r/min) 40000 Oil speed(r/min) 54000
Type Angular contact ball bearing
Tel +86-635-2819662

Bearing sample drawing

Introduction of bearing information

Angular contact ball bearings are mainly subjected to large one-way axial loads. The larger the contact angle, the greater the load bearing capacity. The cage material is steel plate, brass or engineering plastic. The forming method is stamping or turning, depending on the bearing form or the conditions of use. Other combinations of angular contact ball bearings, double row angular contact ball bearings and four-point contact ball bearings.

Angular contact ball bearings can withstand both radial and axial loads. Can work at higher speeds. The larger the contact angle, the higher the axial load carrying capacity. High precision and high speed bearings typically take a 15 degree contact angle. Under the axial force, the contact angle will increase. Single row angular contact ball bearings can only withstand axial loads in one direction and will cause additional axial forces when subjected to radial loads. And can only limit the axial displacement of the shaft or casing in one direction. If it is installed in pairs, the outer rings of a pair of bearings are opposite, that is, the wide end faces the wide end faces, and the narrow end faces the narrow end faces. This avoids causing additional axial forces and limits the shaft or housing to axial play in both directions.

Recommended bearing model